00:00 Note (no change needed): The volume of this track is 86.08dB. LV requires the overall volume for the track (measured by ReplayGain - you can try this tool if you want to check the volume) to be between 86-92dB (with 89dB being the ideal). The file falls within the outer ends of that range and so doesn't need to be changed but watch that it doesn't end up outside the range. The easiest way to automatically set the volume is to use the 'Loudness Normalization' effect (set to -19LUFS in 'perceived loudness' mode) in recent versions of Audacity before exporting the track as an MP3. If you use RMS normalization, set it to -21dB. Another way would be to use the Amplify effect set to 3dB.
04:46 Note (no change needed): The volume change in this section is quite prominent.
Section 9 PL Notes: Thanks for your contribution to this project!
00:00 Note (no change needed): This file contains some clipping. This is where the maximum possible volume is exceeded (possibly because you were too close to your microphone but possibly because the 'gain' for the channel in Audacity was pulled up above 0.0). It can't be changed after recording (unless it was caused by the Audacity gain problem) though a compressor might make it less noticeable.
12:22 We need 5 exactly seconds of silence at the end of the track (as close as you can make it).
Section 9 PL Notes: Thanks for your contribution to this project!
00:00 Note (no change needed): This file contains some clipping. This is where the maximum possible volume is exceeded (possibly because you were too close to your microphone but possibly because the 'gain' for the channel in Audacity was pulled up above 0.0). It can't be changed after recording (unless it was caused by the Audacity gain problem) though a compressor might make it less noticeable.
12:22 We need 5 exactly seconds of silence at the end of the track (as close as you can make it).
