1 minute test - MamaBear9 [OK]

All languages: post your test recording here. Help check audio files.
Post Reply
MamaBear9
Posts: 12
Joined: May 8th, 2024, 5:57 pm

Post by MamaBear9 »

sjmarky
Posts: 4820
Joined: August 28th, 2006, 8:47 pm
Location: Sacto CA
Contact:

Post by sjmarky »

Welcome R

I reviewed your test sample, and while it sounds good there are some technical changes needed. LibriVox requires audio that is 128kbps constant bit rate MP3, 44.1kHz sample rate, mono, and between 86dB and 92dB, preferably 89-90. Your test audio settings are all correct, except the volume which is too low at 79dB.

Make sure input gain slider in Audacity (upper right with the little mic icon) is well to the right. Then adjust the input gain on your mic so your raw recording has wave forms that peak at about the 0.5 marks in the Audacity window:
Image

If necessary, adjust the volume level before exporting by going to Effects>Amplify and enter an amount.

You can pre-check your audio yourself by downloading the free Checker app: https://cgjennings.ca/projects/checker/
Passed with Warnings is a fail with regard to volume.

Please make a new test recording and post it in a reply to this message. I will come back and review it for you.
"Bringing you yesterday's tomorrow...today!"

My website
My Librivox reader page
MamaBear9
Posts: 12
Joined: May 8th, 2024, 5:57 pm

Post by MamaBear9 »

Here is the adjusted copy with higher volume, this one passed the checker test. :)

https://librivox.org/uploads/tests/test_mamabear9.mp3

Thank you so much for your help.
sjmarky
Posts: 4820
Joined: August 28th, 2006, 8:47 pm
Location: Sacto CA
Contact:

Post by sjmarky »

Okay, you are good to go.

Happy narrating!
"Bringing you yesterday's tomorrow...today!"

My website
My Librivox reader page
Post Reply