I am completed my 1 minute test. Thank you for your feedback.
All languages: post your test recording here. Help check audio files, provide editing services, and advertise for proof-listeners.
2 posts • Page 1 of 1
Since you requested to record in one of my projects, I thought I would leave some comments here on your test recording. The reading is fine and the technical specs are correct.crhorne42 wrote: ↑August 2nd, 2020, 5:47 amI am completed my 1 minute test. Thank you for your feedback.
The only problem is that the volume is way to low, measuring only 75.8 dB. Our target is 89 dB with an acceptable range of 86-92 dB. You should see that the wave form in audacity is barely above a straight line. You could probably use the Amplify feature in Audacity to raise this if you set it to +12, but it is better for you to adjust your recording settings. Try setting the input gain higher and/or bringing the microphone closer, until you get an output closer to the target.
Here is a section from our Newbie Guide to Recording that may help: https://wiki.librivox.org/index.php?title=Amplifying
And here is a link to our very useful Checker program that you can use to check the volume in actual dB readings as well as other LV specs. https://wiki.librivox.org/index.php?title=Checker
One other small note: On actual LV recordings, there should be about 5 seconds of silence at the end. Also watch out for recording mouse clicks at the beginning and end.
Please post your new or corrected test recording here again so we can check it.