1-Minute Test for Jackthelad [OK]

[Jackthelad]

https://librivox.org/uploads/tests/test_jackthelad.mp3

Software: Ocenaudio (I have problems with playback on Audacity)
Using Windows 11.

[InTheDesert]

https://librivox.org/uploads/tests/test_jackthelad.mp3

Software: Ocenaudio (I have problems with playback on Audacity)
Using Windows 11.

1 Minute Test Feedback:

Welcome to Librivox and thanks for posting your test file. We look forward to you joining the community!

Reading Feedback:
You have a warm, soothing voice.

Technical Feedback:

• 00:00 The volume of this track is 82.61dB. LV requires the overall volume for the track (measured by ReplayGain - you can try this tool if you want to check the volume) to be between 86-92dB (with 89dB being the ideal). The easiest way to fix this automatically is to use the 'Loudness Normalization' effect (set to -19LUFS in 'perceived loudness' mode) in recent versions of Audacity before exporting the track as an MP3. If you use RMS normalization, set it to -21dB. Another way to fix it would be to use the Amplify effect set to 6dB. Since the volume is so low, amplifying it sufficiently would increase the background noise a lot. Did you accidentally have the microphone slider lower than intended or were you further from the microphone than you should be?

Once you've tweaked these settings, upload the file again using the same filename (uploading to the same filename is important when you are submitting Librivox files) and post in the thread and I'll check it for you again!

[Jackthelad]

Hi, thank you for the feedback.

I've edited the original recording in Audacity using the settings you suggested: https://librivox.org/uploads/tests/test_jackthelad.mp3

[InTheDesert]

Hi, thank you for the feedback.

I've edited the original recording in Audacity using the settings you suggested: https://librivox.org/uploads/tests/test_jackthelad.mp3

The technical specs of your test are fine and you are ready to record! Make sure you use the same settings as your test in future recordings. For any future files you submit, make sure that the intro has 0.75 seconds of silence at the start and 5 seconds of silence at the end. Also check the required filename in the project thread.

The best first step would be to take a section in a group project. You can find a list of open projects here (non-English here).

When you claim your very first section, don't forget to also post the name that you would like to appear in the catalog. Some people use their real name, a pseudonym or just a repeat of their forum username. You might prefer privacy or to use it as an opportunity to advertise yourself as a narrator.