https://librivox.org/uploads/tests/Test_indukantangiras.mp3
Welcome I K
I reviewed your test sample, and while it sounds good there are some technical changes needed. LibriVox requires audio that is 128kbps constant bit rate MP3, 44.1kHz sample rate, mono, and between 86dB and 92dB, preferably 89-90. Your test audio bit and sample rate settings are correct, so well don. The volume however is too low at 83.1dB. The major issue is severe background noise. There is both mechanical noise and an electrical buzz.
Make sure input gain slider in Audacity (upper right with the little mic icon) is well to the right. Then adjust the input gain on your mic so your raw recording has wave forms that peak at about the 0.5 marks in the Audacity window:
If necessary, adjust the volume level before exporting by going to Effects>Amplify and enter an amount.
Try to isolate your mic from the noise, such as computer fan. If that isn’t entirely successful, use Audacity’s Noise Removal filter to reduce the background noise about 10dB. Noise removal instructions are available here: https://wiki.librivox.org/index.php?title=Noise_Cleaning. A video tutorial on Audacity noise removal is available here: https://youtu.be/rvhqw7zBmEo
Check all your cables and connections. Sometimes the cause is a poor connection.
You can pre-check your audio yourself by downloading the free Checker app: https://cgjennings.ca/projects/checker/
Passed with Warnings is a fail with regard to volume.
With Checker open, go to Validation>Choose Validation Methods and check Background Noise. Be sure to leave 5 seconds blank at the end of your recording.
Please make a new test recording and post it in a reply to this message. Please include a list of all the hardware and software you are using. I will come back and review it for you.
I reviewed your test sample, and while it sounds good there are some technical changes needed. LibriVox requires audio that is 128kbps constant bit rate MP3, 44.1kHz sample rate, mono, and between 86dB and 92dB, preferably 89-90. Your test audio bit and sample rate settings are correct, so well don. The volume however is too low at 83.1dB. The major issue is severe background noise. There is both mechanical noise and an electrical buzz.
Make sure input gain slider in Audacity (upper right with the little mic icon) is well to the right. Then adjust the input gain on your mic so your raw recording has wave forms that peak at about the 0.5 marks in the Audacity window:
If necessary, adjust the volume level before exporting by going to Effects>Amplify and enter an amount.
Try to isolate your mic from the noise, such as computer fan. If that isn’t entirely successful, use Audacity’s Noise Removal filter to reduce the background noise about 10dB. Noise removal instructions are available here: https://wiki.librivox.org/index.php?title=Noise_Cleaning. A video tutorial on Audacity noise removal is available here: https://youtu.be/rvhqw7zBmEo
Check all your cables and connections. Sometimes the cause is a poor connection.
You can pre-check your audio yourself by downloading the free Checker app: https://cgjennings.ca/projects/checker/
Passed with Warnings is a fail with regard to volume.
With Checker open, go to Validation>Choose Validation Methods and check Background Noise. Be sure to leave 5 seconds blank at the end of your recording.
Please make a new test recording and post it in a reply to this message. Please include a list of all the hardware and software you are using. I will come back and review it for you.