Software: Audacity
OS: Windows 10
Microphone: Yeti Nano desk microphone
https://librivox.org/uploads/tests/test_nimrod316.mp3
Thanks,
Soren
1 Minute Test [OK]
Welcome Soren
I reviewed your test sample, and while it sounds good there are some technical changes needed. LibriVox requires audio that is 128kbps constant bit rate, 44.1kHz sample rate, mono, and between 86db and 92db, preferably 89-90. Your test audio settings are correct except for the volume, which is too low at 78.9db.
Make sure the the input gain slider in Audacity (upper right with the little mic icon) is well to the right. Then adjust the input gain on your mic so your raw recording has wave forms that peak at about the 0.5 marks in the Audacity window:
If necessary, adjust the volume level before exporting by going to Effects>Amplify.
You can pre-check your audio yourself by downloading the free Checker app: https://cgjennings.ca/projects/checker/
Passed with Warnings is a fail with regard to volume.
Go to Validation>Choose Validation Methods and check Background Noise. Be sure to leave 5 seconds blank at the end of your recording.
Please make a new test recording and post it in a reply to this message. I will come back and review it for you.
I reviewed your test sample, and while it sounds good there are some technical changes needed. LibriVox requires audio that is 128kbps constant bit rate, 44.1kHz sample rate, mono, and between 86db and 92db, preferably 89-90. Your test audio settings are correct except for the volume, which is too low at 78.9db.
Make sure the the input gain slider in Audacity (upper right with the little mic icon) is well to the right. Then adjust the input gain on your mic so your raw recording has wave forms that peak at about the 0.5 marks in the Audacity window:
If necessary, adjust the volume level before exporting by going to Effects>Amplify.
You can pre-check your audio yourself by downloading the free Checker app: https://cgjennings.ca/projects/checker/
Passed with Warnings is a fail with regard to volume.
Go to Validation>Choose Validation Methods and check Background Noise. Be sure to leave 5 seconds blank at the end of your recording.
Please make a new test recording and post it in a reply to this message. I will come back and review it for you.
Hello, and thanks for your reply. Here it is with the volume (hopefully) adjusted.
https://librivox.org/uploads/tests/test_nimrod316.mp3
Thanks, Soren
https://librivox.org/uploads/tests/test_nimrod316.mp3
Thanks, Soren
Okay, you are good to go.
Happy narrating!
Happy narrating!